Ramsey Electronics AR2 Manual de instrucciones descargar pdf (Pagina 19)

ABM1 • 19

 Find the two battery clips. Look carefully at the two clips; the one with the

narrower contact is the (+) clip and to be attached to the Red wire. The

wider contact is the (-) clip and is to be attached to the Black wire. Feed

the Red wire though the appropriate clip from the battery contact side (not

the side that clips into the case). Solder the Red wire into place. Repeat

the process for the black wire and appropriate clip.

CIRCUIT BOARD AND FRONT PANEL ASSEMBLY

 Remove the Battery door from the case bottom (the bottom contains the

battery box and belt clip).

 Adjust the case bottom so that the battery box is facing you with the

battery door opening down.

 Place the circuit board in the case bottom so that J1 comes out the open

end (away from you).

 Lift the end of the circuit board that contains J1 and place the front panel

over J1. Line up the edge of the front panel to fit in the groove of the case

bottom. Drop the circuit board and front panel into place.

 Bring the battery wires down toward the battery box alongside R11.

 Below R11, bring the wires down the left side of the case and R9 toward

the battery box.

 Place the battery clips through the battery cavity.

 Bring one of the battery clips up through the clip slot on the left side of the

battery box with the wire side of the clip up. The clip should snap into

place.

 Repeat previous step for the other battery clip.

THUMBWHEEL ASSEMBLY

 Line up the notch on a thumbwheel with the post on R11. Install the

screw to hold the thumbwheel in place.

 Repeat for second thumbwheel and R4.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Sin comentarios

Ramsey Electronics AR2 Manual de instrucciones Pagina 19