Ramsey Electronics STC1 Manual de instrucciones descargar pdf (Pagina 5)

C2001 • 5

1. Solder the 9 volt positive battery wire (Cube power supply) to

the solder pad labeled "RED" on the Cube and the negative 9

volt battery wire to the pad labeled "BLK" on the Cube.

2. Your camera should have three wires; Red (power +), Black

(ground), Yellow (video). If you have a non-Ramsey camera,

check the paperwork with the camera to be sure which wire

colors indicate positive, negative and video. The Red wire (+)

connects to the 12 volt battery pack positive. BE SURE

YOU’RE CONNECTING TO THE BATTERY POSITIVE

BEFORE SOLDERING.

3. The camera 12 volt battery pack ground must be connected to

the camera and the Cube. The black camera wire is connected

directly to the battery negative or ground (-). Again, double

check the polarity.

4. The black camera wire, now connected to the battery negative

or ground connection (-), must also be connected to the pad

labeled “BLK” on the Cube.

5. The Yellow camera wire (video) connects to the pad labeled

YEL".

When you're finished, check your work to be sure that everything is

connected correctly and the solder pads are not shorted together by a

"blob" of solder. Read the rest of the setup instructions before applying

power.

The Cube

9V Battery

Pack

red

black

yellow

12V Battery

Pack

red

CCD

amera

video out

camera power "+" input

camera power "-" input

black

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Ramsey Electronics STC1 Manual de instrucciones Pagina 5