Ramsey Electronics STC1 Manual de instrucciones

RB1  1 RB-1 • 1 Ramsey Electronics Model No. RB1 Got a problem with furry intruders in your yard or garden? Here is a professional strength r

RB1  10 RB1 SCHEMATIC DIAGRAM

RB1  11

RB1  12 ❒ 11. Install D1, the 1N4002 power diode. This diode prevents the possibility of someone using the incorrect power supply and inadvertently c

RB1  13 ❒ 23. Install C3, a .1uF disc capacitor (marked .1 or 104). ❒ 24. Install C8, another .1uF disc capacitor (marked .1 or 104). ❒ 25. Install C

RB1  14 Bend the capacitor over so that it is lying down on the board and solder both leads (with the cap lying down you should have plenty of room t

RB1  15 INITIAL TESTING: ❒ Connect a suitable 12 volt supply to J1- either 12 VAC or 12 VDC ( positive tip). ❒ Set the frequency range switch to LOW.

RB1  16 TROUBLESHOOTING GUIDE: If your RB1 does not work at all, recheck the following: ❒ correct orientation of diodes, electrolytic capacitors, IC

RB1  17 USING YOUR RAT BLASTER: Certain animals are affected by different frequency settings and other factors that you can change to repel the pests

RB1  18

RB1  19 The Ramsey Kit Warranty Please read carefully BEFORE calling or writing in about your kit. Most problems can be solved without contacting the

RB1  2 PARTIAL LIST OF AVAILABLE KITS RAMSEY TRANSMITTER KITS • FM25B FM Stereo Transmitter • AM1 AM Transmitter • TV6 Te

RB1  20 RB1 Rat Blaster Pest Eliminator Kit Quick Reference Page Guide Introduction ... ...4 How Does It Work? ...

RB1  3 RB1 RAT BLASTER Ramsey Publication No. MRB1 Price $5.00 TABLE OF CONTENTS Introduction ...4 How Does It Wor

RB1  4 INTRODUCTION TO THE RB1 RAT BLASTER This is a practical project for people with problems with furry intruders in their yard, not just rats. T

RB1  5 HOW DOES IT WORK? Here is where we get into a little circuit analysis. If you just want to plug it in and start scaring off critters, you can

RB1  6 RAMSEY “LEARN-AS-YOU-BUILD” ASSEMBLY STRATEGY Be sure to read through all of the steps, and check the boxes as you go to be sure you didn&ap

RB1  7 RAMSEY RB1 PARTS LIST Semiconductors ❒ 1 4001 Quad dual input NOR gate (U3) ❒ 1 XR-2209 voltage controlled oscillator (U2) ❒ 1 NE555 ti

RB1  8 RB1 PARTS LAYOUT DIAGRAM

RB1  9 CONSTRUCTION OF THE RAT BLASTER: Sort out your parts to begin with, making sure you have all of the parts required. You can use old egg carto