Ramsey Electronics PG13 Manual de instrucciones descargar pdf (Pagina 13)

IG7 Page 13

RAMSEY “LEARN-AS-YOU-BUILD” ASSEMBLY STRATEGY

Be sure to read through all of the steps, and check the boxes as you go to be

sure you didn't miss any important steps. Although you may be in a hurry to see

results, before you switch on the power check all wiring and components for

proper orientation. Also check the board for any possible solder shorts, and/or

cold solder joints. All of these mistakes could have detrimental effects on your

kit - not to mention your ego!

Kit building tips

Use a good soldering technique - let your soldering iron tip gently heat the

areas which you are soldering by heating both wires and pads simultaneously.

Apply the solder on the iron and the pad when the pad is hot enough to melt the

solder. The finished joint should look like a drop of water on paper, somewhat

soaked in.

Mount all electrical parts on the top side of the board provided. The top side

is clearly marked with the ‘Silk Screen’ reference designators. This is the side

that has no circuit traces on it. When parts are installed, the part is placed flat to

the board (unless otherwise instructed) and the leads are bent on the backside

of the board to prevent the part from falling out before soldering (1). The part is

then soldered securely to the board (2-4), and the remaining lead length is then

clipped off (5). Notice how the solder joint looks on close up, clean and smooth

with no holes or sharp points (6).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Sin comentarios

Ramsey Electronics PG13 Manual de instrucciones Pagina 13