Ramsey Electronics PG13 Manual de instrucciones descargar pdf (Pagina 16)

RV-1 • 16

JUMPER INSTALLATION:

This is a point in your kit where you will make a decision in how you wish to

configure your kit. There are several different configurations, and we will chart

them for you.

[ ] CONFIGURING INPUTS:

(concerning JMP2, JMP3, JMP4)

Surround sound for Hi-Fi:

• Install none or...

• Install none and remove R4 and R1 to add to the "rear channel"

effect.

Stereo sound from mono source (such as VCR):

• Install JMP2, all others out.

Mono microphone source:

• Install JMP3, JMP4, all others out. Remove R1, R4, R10, and R2.

[ ] CONFIGURING OUTPUTS:

(concerning JMP5, JMP6, JMP7, JMP8, JMP9, JMP10)

Both outputs line level:

• Install JMP5 and JMP7, all others out.

Microphone level on left output, line on right:

• Install JMP6, all others out.

Speaker output on Right, line on left:

• Install JMP8, JMP9, JMP10, all others out.

Speaker output on right, microphone on left:

• Install JMP6, JMP8, JMP9, JMP10. Only JMP7 is out.

Finally! You've just completed the setup and assembly of your RV1 and now

you're almost ready for a test run. First go over all connections and wiring to

check for any mistakes, you sure wouldn't want to try out your kit in a hurry and

damage something that may not be easy to repair.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

Sin comentarios

Ramsey Electronics PG13 Manual de instrucciones Pagina 16