Ramsey Electronics PG13 Manual de instrucciones descargar pdf (Pagina 4)

RV-1 • 4

RV1 REVERB EFFECTS AND SURROUND FEATURES:

• Fully configurable for several different modes of use

• Several adjustments for a wide range of effects from a "chorus" sound,

down to an "outer space" sound

• Configurable as a stand alone unit with speaker audio output and

microphone input

• Configurable for audio line level processing

• Very impressive surround sound effect; makes speakers seem as if they

are all around you.

• 9 volt battery operation

• Good clean distortion free sound

• Ideal for car radios, AV surround sound systems, CB or ham radio,

stereo simulator, voice reverb on PA systems, or any other audio source

INTRODUCTION TO THE RAMSEY RV1 REVERB EFFECTS:

We're sure at one time or another you wished that your TV had surround

sound during your favorite action move or game, or that you had some reverb

effect on your ham radio or CB, or even that your voice had more depth and

reality. These are not the only effects you can do with this kit, there are many

more. We leave more ideas up to your imagination, as it is rewarding to come

up with your own uses for a neat kit like this.

This kit is designed around an IC that uses a set of switched capacitors

called a bucket brigade device. The IC works just like it sounds, with

successive capacitors ("bucket holders") passing their charges from one to

the next on every clock cycle. When the device is running, it causes a time

delay from input to output determined by the clock rate, and the number of

"bucket holders" that the device has inside. When this delayed sound is fed

back into the input, with some decrease in level, it has a reverb effect such

as echoing in a room. This has the same effect as the old reverb spring units

that were inside of electric guitar amps and other equipment, but is immune

to mechanical shock unlike the spring units.

Not only will you find this kit very useful, you'll also find it enjoyable to build,

whether you are a beginner or an experienced kit builder.

NOTE TO NEWCOMERS: If you are a first time kit builder you may find this

manual easier to understand than you may have expected. Each part in the

kit is checked off as you go, while a detailed description of each part is given.

If you follow each step in the manual in order, and practice good soldering

and kit building skills, the kit is next to fail-safe. If a problem does occur, the

manual will lead you step by step through the troubleshooting guide until you

1 2 3 4 5 6 7 8 9 ... 22 23

Sin comentarios

Ramsey Electronics PG13 Manual de instrucciones Pagina 4