Ramsey Electronics STC1 Manual de instrucciones descargar pdf (Pagina 9)

ML1 • 9

 Mount your selected AC outlets to the rear of your case.

 Install your AC line cord through a suitable hole and strain relief device ( a

grommet with a knot tied in the cord inside the case or something similar).

 Select a convenient location in which to mount your finished PC board, but

do not install it yet.

 Drill or punch the appropriate mounting holes for the PC board and make

clearance holes for the controls.

 Check your placement to ensure that no metal or wiring will be exposed

when the case is ‘buttoned up’.

 Solder a set of wires from each outlet to the proper holes on the PC

board - High light to P1 and P2, Mid light to P3 and P4, and Low light to

P5 and P6.

 Solder your line cord to holes P7 and P8 on the PC board. Carefully

examine all wiring for shorts, frayed strands or bad joints.

Testing and Operation

To properly test your ML1 Music Lights, you will need these basic tools and

equipment:

• A source of audio or music such as a stereo or radio

• Three 110 VAC lamps less than 300 watts each

• An RCA phono plug with wires to connect to your audio source.

Connect a pair of wires from the speaker input jack on your ML1 to the speaker

terminal on the audio source you have selected.

• Plug the three lamps you wish to control into the ML1.

• Check to make sure that no wiring is exposed unsafely or metal touching

you or some object on the work table.

• Plug in the line cord from your Music Lights.

• Connect your audio source to the ML1. You can hook the input up in

parallel with your speaker if you wish.

• Advance the volume control on your stereo for a moderate level.

• Adjust each control on the kit for the desired display of lights. If you cannot

get the lights to light up fully, turn up the volume on your stereo. In most

cases, a moderate listening level is adequate.

• Once again, make a safety check and ‘button-up’ your enclosure.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Ramsey Electronics STC1 Manual de instrucciones Pagina 9