Ramsey Electronics FM10A Manual de instrucciones descargar pdf (Pagina 6)

VLF1 • 6

capacitor polarity, transistor shapes, dotted or notched ends

of IC's, and so forth.)

4. Solder all connections unless directed otherwise. Use enough

heat and solder flow for clean, shiny, completed connections.

SINGLE SIDED COMPONENT SOLDERING INSTRUCTIONS:

You’ll notice that the circuit board contains plating on only one side of the

board. This makes soldering relatively easy for even the inexperienced kit

builder. Just take your time and be sure to apply enough heat to the

connections. Don’t be too afraid of overheating a component, most are fairly

hardy and a weak connection will prevent your kit from working properly.

In all RF kits it is a good idea to keep the components as close to the board

as you can and trim off the excess lengths of the component legs. However,

in this kit the highest frequency on the board is around 4MHz, so this isn’t as

critical as it would be in a higher frequency circuit.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Sin comentarios

Ramsey Electronics FM10A Manual de instrucciones Pagina 6