Ramsey Electronics Walking Electronic Bug WEB1 Manual de instrucciones descargar pdf (Pagina 21)

ICI1 Page 21

WIRING AND CUSTOM APPLICATION SUGGESTIONS

Using your DCI1 for a variety of applications is very simple. You just need to

keep in mind the ratings for the relay contacts listed on the specification page

to avoid any problems and use a common sense approach for personal

safety. If you need to operate a simple low voltage DC circuit or switch on and

off a low wattage 120 VAC lighting application, interface your wiring directly to

the J1 through J4 screw terminals and you’re off to the races! For heavily in-

ductive loads such as a large motor or applications that exceed the power rat-

ings of the relays, the following diagrams will help you get started wiring the

DCI1 as a trigger source for a larger relay or similar device.

Typical Low Power DC Wiring:

-LED switch application

- Note that this application will work for any DC appliance (as long as the cur-

rent ratings of the relay are not exceeded). Use care in applying the correct

polarity to the DC device when wiring.

Typical Low Power AC Wiring:

-120 VAC light being switched on Hot side.

(White-Neutral)

(Black-Hot)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Ramsey Electronics Walking Electronic Bug WEB1 Manual de instrucciones Pagina 21