
P-IBM • 7
PARTS SUPPLIED WITH THE P-IBM KIT:
CAPACITORS
[ ] 2 33 picofarad (C6,C9)
[ ] 9 .001 uf [marked .001, 102 or 1nf] (C1,C3,C5,C8,C10,C12,C13,C15,C17)
[ ] 1 .1 uf [marked .1 or 104] (C7)
[ ] 4 4.7 to 10 uf electrolytic (C2,C4,C14,C16)
[ ] 1 220 uf electrolytic capacitor (C11)
FIXED RESISTORS
[ ] 2 100 ohm [brown-black-brown] (R15,R17)
[ ] 2 470 ohm [yellow-purple-brown] (R13,R14)
[ ] 1 2.2K ohm [red-red-red] (R18)
[ ] 1 4.7K ohm [yellow-purple-red] (R5)
[ ] 3 10K ohm [brown-black-orange] (R4,R6,R12)
[ ] 2 15K ohm [brown-green-orange] (R8,R16)
[ ] 1 33K ohm [orange-orange-orange] (R11)
[ ] 4 100K ohm [brown-black-yellow] (R1,R2,R7,R10)
[ ] 1 2.2 megohm [red-red-green] (R3)
SEMICONDUCTORS
[ ] 5 1N914 or 1N4148 diode (D1,D2,D4,D6,D7)
[ ] 2 LED (D3,D5)
[ ] 1 NPN transistor type 2N3904 or similar (Q1)
[ ] 1 Voltage Regulator type 7805 (VR1)
[ ] 1 74HC04 14-pin DIP IC (U1)
[ ] 1 TCM3105 16-pin DIP IC (U2)
OTHER COMPONENTS, HARDWARE
[ ] 1 Ramsey P-IBM printed circuit board
[ ] 1 10K Trimmer potentiometer (R9)
[ ] 1 4.4336 MHz Crystal (Y1)
[ ] 1 PC-mount 5-pin DIN connector (J2)
[ ] 1 PC-mount 9-pin DB9 serial connector (J1)
[ ] 1 Floppy disk, Baycom for IBM
REQUIRED, NOT SUPPLIED
[ ] 1 5-pin DIN plug (male) with cable to match transceiver. Use Radio Shack 42-
2151 for easy Ramsey FX
[ ] 1 Serial computer cable: DB9 male/DB9 female
OPTIONAL:
[ ] Ramsey CIBM case kit
NOTE: optional use of packet software using additional connection to computer
parallel port will require wiring a DB25 connector to PC board points P2,P3,P11,
P15,P18. See instructions on page 15.
Comentarios a estos manuales