Ramsey Electronics SG560 Guía de usuario descargar pdf (Pagina 20)

BASIC OPERATION

2.06.03 Generating CTS

To generate a CTS tone, press CTS. Current

parameters are now shown on the display. To

enter a new CTS tone you will need to know

its frequency, not the tone #. Use the chart at

the end of the manual for standard CTS tones.

This field will accept any selected frequency from 0.1Hz to 999Hz, so non-standard tones may

be used.

Example: To enter a new CTS frequency of 78.5Hz, press

The tone may be toggled on and off by pressing

To enter a deviation value, press

to select the FM field; the icon will blink. To enter a deviation of 300.0Hz, press

Standard CTS deviation is typically 0.75 kHz. Deviation values range from 0.1Hz to 2.5 kHz.

You can set a step/increment value for deviation in the CTS deviation field by pressing the

arrow buttons to test tone decoder sensitivity. To cancel out of either entry press

GENERATE TX Level

Modulation Seq/Reg

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 103 104

Sin comentarios

Ramsey Electronics SG560 Guía de usuario Pagina 20