Ramsey Electronics SG560 Guía de usuario descargar pdf (Pagina 46)

TYPICAL TEST PROCEDURES

3.20.05 Two-Tone Paging

This function allows the COM3010 user to open the squelch of a receiver using the Two-Tone

Paging format.

1. Connect a whip antenna on the generator RF OUT of the COM3010.

2. Set Generate frequency. Example

3. Enter desired RF Level. Example: 4 V Press

4. Press to access the Two Tone Paging Mode.

5. Use the button to access Tone 1 frequency (0.1Hz to 3 kHz).

6. Set Tone One, Example: 378.6 Hz

7. Use the button to access Tone 2 frequency (0.1Hz to 3 kHz).

8. Set Tone Two, Example: 445.7 Hz Press

9. The deviation is set to a default of 4 kHz. To change the deviation press the

button. Enter in a new deviation value. Example: 3.5 kHz, press

10. Press to access the tone type; select between the four types by using the

arrows. See the chart Below.

11. Press to send the test page.

PAGING MODE T1 LENGTH T2 LENGTH SQUELCH WAIT TIME

Tone Only 0.4 seconds 0.8 seconds 1.3 seconds

Tone/Voice 1.0 second 3.0 seconds 1.3 seconds

Battery Save 2.7 seconds 0.8 second 1.3 seconds

Group Call Not Sent 8.0 seconds 1.3 seconds

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 103 104

Sin comentarios

Ramsey Electronics SG560 Guía de usuario Pagina 46