Ramsey Electronics BS2C Manual de instrucciones descargar pdf (Pagina 15)

DCI2 • 15

Initial DCI2 Testing

Now it’s time to do come basic testing to see if your DCI2 is operating

properly. These tests will verify that the microprocessor and tone decoder

circuits are functioning. In order to test the actual outputs you will need to

make up a tester using the extra red LED and 220 ohm resistor included in the

kit. We’ll take you thru the procedure.

Tone decoder & microprocessor test

You will need to have a touch tone signal source connected to J6 in order to

perform these tests. All you need to do is connect the DCI2 to your telephone

line , Just like you connect a telephone, using a standard telephone

connection cable. By lifting the phone receiver and pressing the phone’s

buttons the tones till be generated a dn the DCI2 will decode them. Don’t

worry about any tones or other things like your phone is off-hook or out of

order type messages. The DCI2 will filter them out and ignore them. Once

you have the DCI2 connected follow the steps below. It is important that you

follow the steps exactly or the results may not be as indicated. Don’t just start

randomly pressing buttons. If the results indicated are not achieved, stop and

go to the troubleshooting section of this manual.

1. Make sure both S1 and S2 are not pressed in.

2. Apply power to J5 of the DCI2 and turn it on by pressing S1. The power

LED should light.

3. Connect the DCI2 phone line input, J6, to a telephone line using a

standard RJ11 phone cord. Make sure there is a telephone set nearby

also connected to the phone line.

4. Lift the phone and press the “4” button several times. The activity LED

should flash each time you press the button and you will hear numerous

beeps. If this works proceed to the next step. Otherwise you’ll need to do

some trouble shooting. See the troubleshooting section of this manual.

5. Turn the DCI2 off and back on and then lift the phone receiver and listen

while pressing the “1” button. You should hear the Touch Tones, a single

beep from the DCI2 and the “ACTIVITY” LED on the DCI2 should flash

TWO times.

6. Now press the “#” button. The “ACTIVITY” LED should flash ONCE and

you should hear another single beep.

7. Now press the “2” button. You will hear the Touch Tones, TWO beeps

and the activity light will flash THREE times.

8. Now press the “#” button. The “ACTIVITY” LED should flash ONCE and

you should hear another single beep.

Repeat steps 4 and 5 for each of the buttons on the phone. Each time you

press a number you will hear the corresponding number of beeps in the phone

and the “ACTIVITY” LED will flash the number pressed times plus one. You

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Sin comentarios

Ramsey Electronics BS2C Manual de instrucciones Pagina 15