Ramsey Electronics BS2C Manual de instrucciones descargar pdf (Pagina 20)

DCI2 • 22

Note that the acknowledgment tone is a high pitch tone. If an invalid entry is

made a “RASPBERRY” or lower pitch tone will be heard. If an invalid entry is

made you may continue the programming at the current point by making a

correct entry or turn your DCI2 off and back on and start over.

• To begin programming it is necessary to start from a fresh power

up so press the power switch in to turn on your DCI2.

• Press the programming button. The ACTIVITY indicator will light.

• The first entry sets the output mode.

• Press “*” for DVMS (Digital Voice Messaging System)

• OR

• Press “#” for full BCD output mode

• The ACTIVITY LED should now be off

• The next entry determines if the output is latched after DTMF en-

try or active only when a DTMF tone is present. Note that for

DVMS mode operation only the non-latched mode is available

and any valid DTMF entry may be made.

• Press “*” for non-latched operation

• OR

• Press “#” for latched operation

• The ACTIVITY LED should flash with a valid entry.

• Press “#”. An acknowledgment tone should be heard and the AC-

TIVITY LED should light to indicate the DCI2 is ready for entry of

a security code.

• You will now make four(4) entries as indicated below. Any DTMF

entry may be used. Note that the “*” and “#” keys have special

functions and should not be used in your security code entry ex-

cept as indicated below.

• If no security is desired enter a “#” four(4) times.

• If security is desired enter any four(4) DTMF entries of 0 – 9

and A –D. DO NOT USE THE “*” OR “#” KEYS.

• The ACTIVITY LED should turn off after the first entry and

flash with each of the next 3 entries entry.

• After the last security entry is made an acknowledgment tone will

be heard and the ACTIVITY LED will begin to flash. This indi-

cates completion of programming.

• Now release the PROGRAMMING switch.

• The ACTIVITY LED will turn on and then off and an ac-

knowledgement tone will be heard indicating exit of the

PROGRAMMING MODE.

It is now necessary to turn your DCI2 off and back on to start your DCI2 in the

new configuration. The new configuration will be load on all future start ups

until a new configuration is programmed.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Comentarios a estos manuales

Sin comentarios

Ramsey Electronics BS2C Manual de instrucciones Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para No Ramsey Electronics BS2C